Mounting The Base Unit On A Wall; Troubleshooting - Sony Spread Spectrum 900 Serie Manual De Instrucciones

Paging
You can page the handset from the base unit. Note that you cannot page if the handset is in use.
(HANDSET LOCATOR)
Note
You cannot page the handset when its RING switch is set to OFF.

Mounting the base unit on a wall

1
Raise the hang-up tab.
2
Plug the telephone line cord to the LINE jack and the AC power adaptor to the
DC IN 9V jack, and hook the cords. Use the shorter cord for mounting.
3
Attach the wall bracket to the center of the base unit. Align the f marks of the
wall bracket with those of the base unit.
4
Plug the telephone line cord to the telephone outlet, and hook the base unit to the
wall plate.
5
Plug the AC power adaptor to an AC outlet. Then raise the antenna so that it
points towards the ceiling.
1 2
Telephone
line cord
Hang-up tab
AC power
adaptor cord
Tip
To remove the wall bracket, press the lower tabs.
Maintenance
• Clean the cabinets with a soft cloth slightly moistened with water or a mild detergent
solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol
or benzine as they may damage the finish of the cabinet.
• If the charge terminals of the base unit and handset are soiled, wipe them with a soft cloth.
If you have any questions or problems concerning your phone, please consult your nearest
Sony dealer.
Notes on power sources
On battery pack
• Store the battery pack at a temperature between 41°F (5°C) and 95°F (35°C) for best
performance.
• If you do not use the phone for a long period of time, remove the battery packs from the
handset after charging for more than 12 hours, and base unit after charging for more than 24
hours when you have a spare battery. Then unplug the AC power adaptor.
On power failure
• During a power interruption, you cannot make or receive calls.
For the customers in the USA
RECYCLING NICKEL-CADMIUM BATTERIES
Nickel-Cadmium batteries are recyclable. You can help preserve our environment
by returning your unwanted batteries to your nearest point for collection, recycling
or proper disposal.
Note: In some areas the disposal of nickel-cadmium batteries in household or
business trash may be prohibited.
RBRC (Rechargeable Battery Recycling Corporation) advises you about spent
battery collection by the following phone number.
Call toll free number: 1-800-822-8837 (United States and Canada only)
Caution: Do not handle damaged or leaking nickel-cadmium batteries.
To page
Press (HANDSET LOCATOR).
The handset rings for about one minute.
To stop ringing, press (TALK) or (OFF) on the
handset.
4, 5
3
Wall plate
1
2
Wall
bracke
AC outle

Troubleshooting

Should any problem persist after you have made these checks, consult your nearest authorized
Sony dealer.
Symptom
You cannot make or receive calls.
You hear no dial tone.
The phone does not connect at all,
even the number you dial is correct.
The phone does not redial correctly.
You hear five short error beeps when
you try to redial.
You cannot store a speed dial number. • Make sure the number (including the tone and pause
The handset does not ring.
You hear interference during
conversation.
You hear a beep every second during
conversation.
You hear a beep twice per second and
the BATT LOW lamp flashes.
The handset does not work.
Specifications
General
Spread method
Access method
Frequency band
Operation channel
Supplied accessories
Handset
AC power
Power source
adaptor
Battery life
Battery charging time
Dimensions
Mass
Base unit
Power source
Battery charging time
Dimensions
Mass
Design and specifications are subject to change without notice.
Remedy
• Place the base unit away from noise sources.
• Move the handset closer to the base unit.
• Make sure you set up the base unit correctly.
• Make sure the battery is fully charged.
• Make sure the dialing mode setting (pulse or tone) is
correct.
• Make sure the last dialed number is really the one you
want to dial.
• The number you last dialed exceeds 32 digits (including
the tone and pause digits if used).
• The number you last dialed is erased.
digits) does not exceed 20 digits.
• Set the RING switch to ON.
• Move the handset closer to the base unit.
• Place the base unit away from noise sources.
• It is an out-of-range alarm. Move the handset closer to
the base unit within one minute.
• The battery is weak. Charge the battery for more than 12
hours.
• The battery may be weak. Charge the battery for more
than 12 hours.
Direct-Sequence Spread-Spectrum
FDMA-TDD
902 - 928 MHz
14 channels
AC power adaptor
Telephone line cords (2)
Rechargeable battery pack BP-T31
Directories (2 sheets)
Wall bracket
Rechargeable battery pack BP-T31
Standby: Approx. 7 days (RING ON mode)
Approx. Three weeks (RING OFF mode)
Talk: Approx. 6 hours
Approx. 12 hours
Approx. 56 × 183 × 55 mm (w/h/d), antenna excluded
1 1 1
(approx. 2 / × 7 / × 2 / inches)
4 4 4
Antenna: Approx. 75 mm (approx. 3 inches)
Approx. 250 g (approx. 8.8 oz), battery included
DC 9V from AC power adaptor
Approx. 24 hours
Approx. 123 × 70 × 225 mm (w/h/d), antenna excluded
7 7 7
(approx. 4 / × 2 / × 8 / inches)
8 8 8
Antenna: Approx. 165 mm (approx. 6 ½ inches)
Approx. 350 g (approx. 12 oz), wall bracket excluded