Everyday Maintenance; Operating Faults; Possible Incidents - Eurocave Revelation Serie Manual De Instrucciones

Your EuroCave cabinet is a tried and tested appliance.
Maintenance operations to be carried out approximately
once a year
•
Unplug and unload the appliance.
•
Regularly vacuum the condenser at the back of the appliance.
•
Clean the inside of the compartments with water and a gentle cleaning product.
•
Rinse thoroughly.
•
Replace the active charcoal filter in the breather hole at the top of your cabinet
•
Remove the charcoal filter manually. It is available from your usual retailer. It
must be replaced by an original manufacturer's part.
•
Check that the seals are in good condition.
•
Clean the light strip with a microfibre or soft cloth only.
•
To remove text, written using the white marker pen, from the bottle
identification supports, use a damp cloth.
•
To clean the fronts of the shelves:
- use a microfibre or soft cloth only
- only use water or a cleaning product designed for glass
Never use cleaning products containing acetone, spirit or alcohol, white
spirit or synthetic thinners which could damage the front of the shelf.
Stainless steel:
•
To clean the stainless steel surface, we recommend a neutral liquid soap solution.
•
Make sure that the soap does not contain abrasive additives that might harm the finish.
•
Apply solution with a soft cloth.
•
The cloth should not have any buttons, zips etc. that might scratch the stainless steel.
•
Rub the surface following the brushed direction.
•
Dry with a soft clean cloth following the brushed direction.
Never pour liquid directly onto the stainless steel. Never use chemical solvents, abrasives or granular cleaners, petrol or alcohol,
all of which could harm the cabinet surface. No chlorine-based products.

Possible incidents

The pictogram is displaying
The pictogram is still displaying
even though I have taken the corrective
actions above
The pictogram is displaying
The pictogram is flashing
The appliance cannot lower the level of
humidity to the desired value
The pictogram is displaying
The pictogram is displaying
If your appliance does not seem to be working correctly, contact your EuroCave retailer.
7 - E
Causes Corrective actions
The temperature has Check that the door is correctly closed.
not returned to within Check the condition of the door seal.
the ±4 °C threshold If you placed a large amount of bottles in your cabinet in the last few hours,
wait a while then check again. If the alarm is still displaying, contact your
EuroCave retailer.
Operating fault Unplug the cabinet and contact your EuroCave retailer.
Open door alarm Make sure that the door is correctly closed.
The level of relative • Pour a glass of water into the duct of the tray (see chapter 7, § IV).
humidity has been < • In order to know how often to add water, count the number of days
50 % for over 72 hrs separating the 1st day you added water and the day when the pictogram was
displayed
After a few hours, the pictogram will disappear.
• Empty the cabinet, remove the humidity cartridge and clean the tray.
• Remove the tube placed at the back of the tray. The humidity will be directly
discharged out of the appliance.
Call the EuroCave retailer if the problem persists despite having carried out
these different operations.
Charcoal filter alarm Replace the charcoal filter (see chapter 4).
Temperature sensor Contact your EuroCave retailer.
fault alarm
VERYDAY MAINTENANCE
8 - O
PERATING FAULTS
17
GB