Info Mode; Activating The Info Mode; Info Off Mode; Calling The Quick Menu - Dräger X-am 2500 Instrucciones De Uso

4.7

Info Mode

4.7.1

Activating the Info mode

In measuring mode, press the OK key for approx. 3 seconds.

If any warning or fault messages exist, the corresponding note or

error codes are displayed (see Technical Handbook).
Press the OK key successively for the next display. The peak
values and the exposure values TWA and STEV will be displayed.
If no key is pressed for 10 seconds, the instrument returns

automatically to measuring mode.
4.7.2

Info Off mode

Press the [+] key when the instrument is turned off.

The name of the gas, measuring unit, and measuring range limit
value are displayed for all channels.
Press the [+] key again to exit the Info Off Mode (or via timeout).

Dräger X-am 2500
4.8

Calling the Quick Menu

In measuring mode, press the [+] key three times.

If functions in the quick menu are activated using the PC software

"Dräger CC Vision", you can select these functions using the
[+] key. If no functions have been activated in the quick menu,
the instrument remains in measuring mode.
Possible functions: 1. Bump test (configuration for bump test,
see technical manual)
2. Fresh air calibration
3. Delete peak values
4. Display pump information,
see technical manual
5. Activate or deactivate pump,
see technical manual
Press the OK key to activate the selected function.

Press the [+] key to cancel the active function and to switch to

measuring mode.
If no key is pressed for 60 seconds, the instrument returns

automatically to measuring mode.
Operation
29