Maintenance; Cleaning; Replacing The Battery - Amprobe VPC-10A Manual De Instrucciones

MAINTENANCE

W Caution
- To prevent damage to the VPC-10A:
• Do not attempt to repair or service the VPC-10A unless qualified to do so.
• Make sure that the relevant calibration, performance tests, and service
information is being utilized.
• Do not use abrasives or solvents.

Cleaning

The only maintenance the VPC-10A requires is inspection and cleaning.
Periodically wipe the case with a mild solution of detergent and water.
Apply sparingly with a soft cloth and allow time to dry completely before
using. Do not use aromatic hydrocarbons, gasoline or chlorinated solvents
for cleaning.

Replacing the Battery

Replace the batteries immediately if the continuity LED doesn't turn on
when touching both probes together.
W Warning
• To avoid electric shock, disconnect the test leads from the source before
opening the VPC-10A for battery replacement.
• To avoid false readings, which could lead to possible electric shock or
personal injury, replace the battery as soon as the battery is low or
dead.
The VPC-10A uses three 1.5V batteries. To replace the batteries, follow these
steps and refer to Figure 6:
1. Disconnect test leads from any power source.
2. Place the VPC-10A face down on a non-abrasive surface and loosen the
battery-door screw with a Phillips screwdriver.
3. Lift the battery cover away from the VPC-10A.
4. Replace the battery as shown in Figure 6. Observe the battery polarity
shown in the battery compartment.
5. Secure the battery cover back in position with the screw.
10