Fitting The Collar; Cautions For Use - Num'axes Iki Voice Manual De Instrucciones

Changing the sensor
Two different length sensors are included in the package. The size should be long enough to have
proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long haired dog and the short sensor fitted to the collar in the factory is inadequate,
remove the short sensor and replace it with the long one supplied with the kit.
When changing the sensor, do not press on the threaded rod, it could damage the components
underneath. A moderate manual screwing is sufficient (do not use any key). If you screw the sensor
too much, bark detection is likely to be inefficient.

Fitting the collar

The strap should be adjusted so that the sensor comes right into contact with the dog's skin in order
to ensure good barking detection.
- If the strap is too loose, the collar will not operate properly. Moreover, it might move around the
dog's neck and repeated rubbing of the sensor on the skin can cause irritation.
- If the strap is too tight, the dog will have difficulties in breathing.
You must be able to let 2 fingers go between the collar's strap and the dog's neck.
You must to able to let 2 fingers go between the collar's strap and the dog's neck.
Regularly check your dog's neck as repeated rubbing of the sensor on the dog's skin may cause
irritation. If this happens, remove the collar until all signs of skin irritation have disappeared.
Do not leave the collar more than 8 hours a day around your dog's neck and take the time to check
that there are no signs of irritation when your dog is not wearing it.
Checking the device operates correctly
- Switch on the collar (by setting your collar on mode 3 you can both test vibration and vocal messages).
- Slowly rub the sensor on a slightly rough surface (change the detection sensitivity if necessary).
- The collar will emit vibrations and/or beeps and/or restores your vocal messages (according to the
chosen configuration).
IMPORTANT : after being activated 3 times in quick succession, the collar will automatically go into
safety mode for 15 seconds, before restarting itself normally.

Cautions for use

- The collar should be used on dogs only over 6 months old.
- Before using the collar, it is important to have your dog checked by your vet to ensure it is fit to wear
a bark limiter.
- The collar is weatherproof but not waterproof.
- To avoid unintentional triggering, the dog should not wear any medal, metallic collar, or any other
kind of collar together with the bark limiter collar.
- If you do not use the collar for a long period of time, we advise you to remove the battery.
- Never leave a discharged battery in the collar.
- Keep the collar out of reach of children.
Gb - 19