Changing The Contact Points; Fitting The Collar - Num'axes Iki Pulse Manual De Instrucciones

Checking/reloading battery
When the indicator light flashes in red when switching On or Off the collar, it indicates that the battery is
too weak for the operation of the product.
The product switches to safety mode, it is out of use.
It is necessary to recharge the battery for at least 6 hours. But a full charge of the battery is
recommended (12 hours). Follow the procedure indicated above, at the beginning of the user's guide
(See § Charge of the product).

Changing the contact points

Two different length contact points are included in the package. They should be long enough to have
proper contact with the dog's skin, enabling the device to operate correctly. If you have a long haired
dog and the short contact points fitted to the collar in the factory are inadequate, remove the short
contact points and replace them with the long ones supplied with the kit.
When changing the contact points, do not use a key for tightening or untightening them because it
could damage some components.
A moderate manual screwing is sufficient.

Fitting the collar

The strap should be adjusted so that the contact points come right into contact with the dog's skin in
order to ensure good barking detection.
- If the strap is too loose, the collar will not operate properly. Moreover, it might move around the dog's
neck and repeated rubbing of the contact points on the skin can cause irritation.
- If the strap is too tight, the dog will have difficulties in breathing.
Regularly check your dog's neck as repeated rubbing of the contact points on the dog's skin may
cause irritation. If this happens, remove the collar until all signs of skin irritation have disappeared.
Do not leave the collar more than 8 hours a day around your dog's neck and take the time to check
that there are no signs of irritation when your dog is not wearing it.
Checking the device operates correctly
Before doing so, make sure that the collar is turned off.
- Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and
retightening them so as to pinch the test lamp wires).
- Switch on the collar (turn the collar on mode 2, 3 or 4, thus you will be able to check the
operation of beep sound and stimulation).
Gb - 15