Foppapedretti GO! EVOLUTION Manual De Instrucciones página 14

• ENGLISH •
YOUR GROUP 0-1 CAR SEAT (1)
This seat is classified as group 0/1 for children from 0 to 18 kg ( birth to 4 years approx.)
1. Shell + cover
2. Harness + shoulder pad (x2)
3. Adjuster (x2)
4. Adjustment strap (x2)
5. Harness buckle
6. Base
7. Blue lock-off clip (for rearward facing use only)
8. Infant reducer cushion
9. Pillow
10. Diagonal belt guides (x2 - for rearward facing use only)
11. Red belt lock-off (x2 - for diagonal belt (forward facing use only)
12. Lap belt guides (x2 - for forward facing use only)
13. Lap belt guides (x2 - for rearward facing use only)
14. Seat reclining lock
ADJUSTING THE HARNESSES
Make sure that the harness of your car seat is adapted to the height of your child before
starting to install the seat in your car. The harnesses can be adjusted to 4 different
heights and must be positioned as close as possible to your child's shoulders (2).
• The two lower positions are ONLY intended for use in group 0, for a child weighing
from 0 to 10 kg in a rear-facing position. If your child's shoulders are between two levels
in a rear-facing configuration, choose the lower of the two.
• The two upper positions are ONLY intended for use in group 1, for a child weighing
from 9 to 18 kg in a front-facing position. If your child's shoulders are between two
levels in front-facing configuration, choose the higher of the two.
To adjust the height of the harnesses, remove the upper section of one of the harness
straps by pivoting the metal anchor located behind the back rest and then pulling it
through the slots of the shell and cover (3). Repeat the operation on the upper section
of the second strap.
Feed the ends of the harness straps through the slots at identical level in both the cover
and the shell, according to the chosen configuration:
• For a rear-facing configuration (Gr. 0, from 0 to 10 kg), the harnesses are fed through
one of the two lower positions and then up to the third position to be secured inside the
shell (4) (5). Make sure that the metal anchor is correctly positioned and that the ends
14