Foppapedretti GO! EVOLUTION Manual De Instrucciones página 15

• ENGLISH •
of the harness straps are not twisted.
IMPORTANT: Whichever of the two lower positions you have chosen, make sure that the
metal anchors of the harnesses are well secured through the slots of the third position
of the shell.
• For a front-facing position (Gr. 1, from 9 to 18 kg), the harnesses are fed through one
of the two upper positions and are secured directly behind the position chosen, at the
back of the shell (6) (7). Make sure that the metal anchor is correctly positioned and
that the ends of the harness straps are not twisted.
THE CORRECT TYPE OF SAFETY BELT TO USE WITH YOUR CAR SEAT
Your car seat must ONLY be installed on a passenger seat fitted with a 3-point safety
belt. NEVER install your car seat on a passenger seat fitted with a 2-point safety belt!
(i - 0-10 kg) (i - 9-18kg).
REARWARD FACING USE (0 - 10 kg)
DO NOT USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED WITH AN AIR BAG!
When used rearward facing, the child seat must be in the fully reclined position.
Pull lap and diagonal sections of the car seat belt until fully extended and feed both
through the space between the shell and the base. Fasten the seat belt.
Thread the lap section through the guides located at the front of the base (8).
Thread the diagonal strap through the two upper guides located on the back of the seat
shell (9).
Tighten the seat belt by pulling first on the lap section, then on the diagonal one (10).
Check that there are no kinks or twists in the seat belt.
Lock the 2 sections of the belt with the blue lock-off clip. The lock-off should be
positionned against the buckle of the seat belt (11).
Do not use the red lock-off for the rearward facing installation. Always keep the seat in
the most reclined position.
FORWARD FACING USE (9-18 kg)
Fully recline the seat. Pull lap and diagonal sections of the car seat belt until fully
extended and feed both through the space between the shell and the base. Fasten the
seat belt (12).
Thread the lap section through the guides located below the red lock-off clips. Open the
red lock-off clip next to the buckle, then route the diagonal section of the belt through
the open lock-off clip (13).
Push the child seat right down into the car seat, and tighten both sections of the seat
belt by pulling the belt in the direction shown (14).
15