Read Mode; Parameter-Setting Mode - Leroy-Somer VARMECA 10 Instrucciones De Uso

LEROY-SOMER

2.3 - Read mode

If when the console is powered up, it is not
connected to the VARMECA 10 or if the VARMECA
10 is switched off, the message CONSOLE LINK
FAULT will appear
- Power up the VARMECA 10.
- Connect the 230 V socket on the console power supply
unit.
- On power-up, the console display is positioned on the 1st
parameter PO1 FMIN.
The 1st line of the display unit indicates the parameter
designation.
The 2nd line indicates the parameter value and unit.
The key is used for scrolling through parameters P01
to P29.
The key is used for scrolling in the opposite direction.
38
PARAMETER-SETTING MANUAL
VARMECA 10
Variable speed motors and geared motors
COMMISSIONING THE CDC-VMA CONSOLE

2.4 - Parameter-setting mode

Parameter modifications must be performed with
the VARMECA 10 stopped (run command disabled)
To modify a setting, use the
parameter.
The key is used to make the parameter, which is to be
modified, flash.
Modify the setting value with the
As soon as the value differs from the stored value, the MEM?
message appears.
When the desired setting value has been reached, it can be
stored using the MEM. key.
The MEM? indication disappears.
The key is used to quit the parameter-setting mode.
Ref. 3264 - 4.33/b -1.00
or keys to select the
or keys.