Preparing The Remote Control; Demo Function; Placement Of Speakers - Panasonic SC-PM46 Instrucciones De Funcionamiento

Sistema estéreo con reproductor de discos compactos
Ocultar thumbs Ver también para SC-PM46:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparing the remote control

CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's
instructions.

DEMO function

Placement of speakers

Speakers are designed identically so that no left or right channel orientation is necessary.
Use only the supplied speakers.
The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and sound quality will be
negatively affected.
Note
• Keep your speakers at least 10 mm (
• These speakers do not have magnetic shielding. Do not place them near televisions, personal computers or other devices easily infl uenced
by magnetism.
• To avoid damage to the speakers, do not touch the speaker cones if you have taken the nets off.
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of time.
Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct sunlight for a
long period of time with doors and windows closed.
• Mishandling of batteries in the remote control can cause electrolyte leakage,
which may cause a fi re.
Do not:
• mix old and new batteries;
• use different types of batteries at the same time;
• take apart or short-circuit;
• attempt to recharge alkaline or manganese batteries;
• use batteries if their covering has been peeled off.
■ Use
Aim at the remote control sensor, avoiding obstacles, at a maximum range of
7 m (23 feet) directly in front of the unit.
Refer to page 6 for remote control signal sensor position.
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO
ON".
Press and hold [7, –DEMO].
The display changes each time the button is held down.
While in standby mode, select "DEMO OFF" to reduce power consumption.
13
/
˝ ) away from the system for proper ventilation.
32
Caution
• Use the speakers only with the recommended
system. Failure to do so can damage the amplifi er
and speakers, and can cause fi re. Consult a qualifi ed
service person if damage occurs or if a sudden change
in performance is apparent.
• Do not attach these speakers to walls or ceilings.
5
5

Publicidad

Tabla de contenido
loading

Tabla de contenido