Placement Of Speakers; Preparing The Remote Control; Demo Function - Panasonic SC-PM42 Instrucciones De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Placement of speakers

Speakers are designed identically so that no left or right channel
orientation is necessary.
Use only the supplied speakers.
The combination of the main unit and speakers provide the best sound.
Using other speakers can damage the unit and sound quality will be
negatively affected.

Preparing the remote control

Batteries
Use a manganese dry battery or an alkali dry battery.
Insert so the poles (+ and –) match those in the remote control.
Remove if the remote control is not going to be used for a long period
of time.
Store in a cool, dark place.
Do not heat or expose to flame.
Do not leave the batteries in an automobile exposed to direct sunlight
for a long period of time with doors and windows closed.
Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fire.
Use
Aim at the remote control sensor, avoiding obstacles, at a maximum
range of 7 m (23 feet) directly in front of the unit.
Refer to page 6 for remote control signal sensor position.

DEMO function

POWER
iPod
USB
FM/AM
/
/
SC-PM42PP,PC.indb 5
[g, –DEMO]
DEMO
VOLUME
VOLUME
CD
/
_
+
OPEN/CLOSE
Note
Keep your speakers at least 10 mm (13/32") away from the system for
proper ventilation.
These speakers do not have magnetic shielding. Do not place
them near televisions, personal computers or other devices easily
influenced by magnetism.
To avoid damage to the speakers, do not touch the speaker cones if
you have taken the nets off.
You can damage your speakers and shorten their useful life if you play
sound at high levels over extended periods.
Reduce the volume in the following cases to avoid damage.
− When playing distorted sound.
− When adjusting the sound quality.
− When turning the unit on or off.
Caution
Use the speakers only with the recommended
system. Failure to do so can damage the amplifier
and speakers, and can cause fire. Consult a
qualified service person if damage occurs or if a
sudden change in performance is apparent.
Do not attach these speakers to walls or ceilings.
Place this side in before the other side
Do not:
mix old and new batteries;
use different types of batteries at the same time;
take apart or short-circuit;
attempt to recharge alkaline or manganese batteries;
use batteries if their covering has been peeled off.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
When the unit is first plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [g, –DEMO].
The display changes each time the button is held down.
DEMO OFF
While in standby mode, select "DEMO OFF" to reduce power
consumption.
R6/LR6, AA
DEMO ON
2/5/2010 10:55:20 PM
5
5 5

Publicidad

Tabla de contenido
loading

Tabla de contenido