Selecting The Saw Blade; Changing The Saw Blade - Festool TSC 55 REB Manual De Instrucciones

4
0° - 45°
4-1
4-2
47°
4-3
-1°
8.4

Selecting the saw blade

Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Colour
Yellow Wood
Red Laminated wooden pan­
els
Green Eternit fibre cement
panels
Blue Aluminium, plastic
8.5

Changing the saw blade

CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
► Swivel the machine to 0° before replacing
the saw blade and adjust the maximum cut­
ting depth.
► Turn the lever [5-3] as far as the stop.
Operate lever [5-3] only when the machine
is at a standstill!
► Push the saw down until it engages.
► Open the screw [5-6] using the Allen
key [5-2].
► Remove the saw blade [5-7].
4-1
-1°
-1° / 47°
4-4
Material Symbol
► Insert a new saw blade.
The direction of rotation of the saw
blade [5-8] and machine [5-4] must match!
Serious injuries may occur in the event of
non-compliance.
► Insert the outer flange [5-9] so that the
pulling peg engages in the recess of the in­
ner flange.
Check screws and flange for dirt con-
tamination and only use clean and un-dam­
aged parts!
► Tighten the screw [5-6].
► Pull the lever [5-3] back.
5
5-5
5-6
5-7
5-8
5-9
8.6 Fitting the viewing window/splinter
guard [6]
The viewing window (transparent) [6-1] pro­
vides a view of the saw blade and optimises
dust extraction.
With 0° cuts, the splinter guard (green) [6-2]
also improves the quality of the cutting edge of
the sawn-off workpiece on the upper side.
► Insert the splinter guard [6-2].
► Screw the rotary knob [6-3] through the
long hole in the splinter guard.
Make sure that the nut [6-4] is seated
securely in the splinter guard.
English
5-1
5-2
5-3
5-4
15