Selecting The Saw Blade; Changing The Saw Blade; Working With The Electric Power Tool - Festool KSC 60 EB Manual De Instrucciones

The contact surface of the stop rulers can
be individually adjusted by screwing in
suitable tap blocks [8B]. When doing so,
ensure that the functionality of the saw is
not restricted in any way.
8.7

Selecting the saw blade

Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Refer to the necessary saw blade data (see sec­
tion 3.1).
Colour Material
Yellow Wood
Red Laminate, mineral ma­
terial
Green Plaster- and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
8.8

Changing the saw blade

WARNING
Risk of injury
► Remove both battery packs from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Preparing the machine
► Move the saw unit into the rear position and
lock it in place using the rotary knob [9-3].
► Move the saw unit upwards until it reaches
the limit stop.
► Pull the lever for the transport locking de­
vice [9-2].
► Remove the hex key [9-9] from the holder in
the key storage box [9-11] .
Removing the saw blade
► Press and hold the spindle stop [9-1].
► Use the hex key [9-9] to turn the saw blade
until the spindle stop clicks into place.
► Use the hex key to undo the screw [9-8]
(left-hand thread, turn in the direction of
the arrow).
► Remove the screw and flange [9-7].
► Release the spindle stop.
► Press and hold the safety button [9-4].
► Lift and hold the pendulum guard [9-5] with
one hand.
► Remove the saw blade [9-6].
Inserting the saw blade
WARNING! Check the screws and flange for
Symbol
contamination and only use clean and undam­
aged parts.
► Insert the new saw blade [9-6].
WARNING! The writing on the saw blade
must be visible. The saw blade's direction of
HPL/TRESPA ®
rotation must correspond to the direction of
the arrow [9-10].
► Insert the flange [9-7] in such a way that
the flange, holding thread and saw blade all
interlock perfectly with each other.
► Press and hold the spindle stop [9-1].
► Use the hex key [9-9] to turn the saw blade
until the spindle stop clicks into place.
► Insert the screw [9-8] and tighten it against
the direction of the arrow.
ly in place. If a screw is loose, the saw blade
may become detached.
9
Flying tool parts/workpiece parts
Risk of injury
► Wear protective goggles.
► Ensure that no other persons are close to
► Always clamp workpieces tightly.
► The clamps must be fully laid out.
The pendulum guard does not close
Risk of injury
► Stop the sawing process.
► Remove the battery pack, remove offcuts.
Risk of injury! Whenever you replace a
saw blade, always check that it is secure­
Working with the electric
power tool
WARNING
the machine while it is being used.
WARNING
In the event of damage, remove the pendu­
lum guard.
English
31