Adjusting The Cutting Depth - Festool TSC 55 REB Manual De Instrucciones

English
8.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Constant speed
The motor speed is electronically kept con­
stant. This ensures a uniform cutting speed
even when under load.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-10] (see Technical data). This enables
you to optimise the cutting speed to suit specific
surfaces (see Section
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The power tool omes with an electronic brake.
The saw blade is stopped electronically within
approximately two seconds of switching off the
machine.
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the motor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
8.2

Adjusting the cutting depth

The cutting depth can be adjusted to between
0 - 2-1/8" (0 - 55 mm) on the cutting depth
stop [3-1]:
The sawing unit can now be pressed down to
the set cutting depth.
Cutting depth without guide rails
max. 2-1/8" (55 mm)
Cutting depth with guide rail FS
+FS max. 1-15/16" (51 mm)
14
9.7 ).
3
+FS
3-1
8.3 Adjusting the cutting angle
between 0° and 45°:
► Unscrew the rotary knobs [4-1].
► Swivel the sawing unit to the desired cutting
angle [4-2].
► Tighten the rotary knobs [4-1].
Both positions (0° and 45°) are set at
the factory and can be readjusted by
the customer service team.
When making angled cuts, slide the view­
ing window/splinter guard to the highest
position.
to undercut -1° and 47°:
► Swivel the saw unit to the end position (0°/
45°) as described above.
► Pull out the release button [4-3] slightly.
► For -1° undercuts, also pull the release
button [4-4].
The saw unit engages in the -1°/47° posi­
tion.
► Tighten the rotary knobs [4-1].