Tabla de contenido
Publicidad
BOBBIN SETTING
Be sure to use only SINGER Class 15 bobbins in
this machine.
A. REMOVING THE BOBBIN
1. Pull the bobbin cover latch to the right and
remove the bobbin cover.
2. Lift up the bobbin from the machine.
B. SETTING SPOOL OF THREAD ON
SPOOL PIN
1. Pull up the left end of spool pin and set the spool
of thread on spool pin so that the thread unrolls
from the front of the spool.
2. Set the spool cap on spool pin as far as it will go.
a: Reverse spool cap direction according to the
size of spool.
b. Use the small spool cap when you use cross
wound thread. Leave small opening between
cap and spool as illustrated.
C. WINDING THE BOBBIN
1. Hold thread in both hands and hook thread to
the guide from front opening.
2. Bring thread towards the rear of the machine and
pass through the thread guide from left to right.
3. Bring thread to the right and pass thread through
the thread guide from rear side. Pass thread
under tension disc in counter clockwise direction,
making sure it is pulled snuggly between the
discs.
4. Insert thread through hole in bobbin and place
the bobbin on bobbin winder spindle. Push
bobbin to the right to engage bobbin winder.
LCD will indicate the bobbin winding mode.
5. Hold the end of the thread and start the machine
by pressing the start/stop button or pressing the
foot control pedal.
6. After the bobbin winds a few turns, stop the
machine by pressing the start/stop button or
releasing the foot control pedal. Cut the thread
near hole.
7. Start the machine again.
8. The bobbin winding will stop automatically when
bobbin is full. Release the foot control pedal.
9. Push the bobbin and spindle to the left.
10. Remove the bobbin from the spindle and cut the
thread.
32
Publicidad
Tabla de contenido
