Stihl MS 251 Manual De Instrucciones página 21

Ocultar thumbs Ver también para MS 251:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

D =Felling Cut
D
Conventional and open-face technique:
Begin 1 to 2 inches (2,5 to 5 cm)
N
higher than center of felling notch.
Cut horizontally towards the felling
N
notch.
Leave approx.1/10 of diameter
N
uncut. This is the hinge.
Do not cut through the hinge – you
N
could lose control of the direction of
the fall.
Drive wedges into the felling cut where
necessary to control the fall.
WARNING
If the tip of the bar contacts a wedge, it
may cause kickback. Wedges should be
of wood or plastic – never steel, which
can damage the chain.
MS 251, MS 251 C
E = Hinge
D
Helps control the falling tree.
N
Do not cut through the hinge – you
N
could lose control of the direction of
the fall.
E
E
Felling Cut for Small Diameter Trees:
Simple Fan Cut
Engage the bumper spikes of the chain
saw directly behind the location of the
intended hinge and pivot the saw around
this point only as far as the hinge. The
bumper spike rolls against the trunk.
English
19

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido