Stihl MS 251 Manual De Instrucciones página 41

As Soon as Engine Runs
4
3
Press down trigger trigger lockout
N
and the blip the throttle trigger (3) –
the Master Control lever (4) moves
to the run position (F) and the
engine settles down to idling speed.
NOTICE
As the chain brake is still engaged, the
engine must be returned to idling speed
immediately – or the engine housing and
chain brake might otherwise be
damaged.
Pull the hand guard back toward the
N
front handle.
The chain brake is now disengaged –
your saw is ready for operation.
MS 251, MS 251 C
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
STOP
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
0
At very low outside temperatures
Allow engine to warm up at part
N
throttle.
Change over to winter operation if
N
necessary – see "Winter Operation".
Shutting Off the Engine
Move the Master Control lever to the
N
stop position (0).
If Engine Does Not Start
If you did not move the Master Control
lever from the choke closed
position (l) to the starting throttle
position (n) quickly enough after the
engine began to fire, the combustion
chamber may be flooded.
Move the Master Control lever to the
N
stop position (0).
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Refit the spark plug – see "Spark
N
Plug".
Set Master Control lever to the
N
starting throttle position (n) – even
if the engine is cold.
Now start the engine.
N
English
39