WIKA 232.50 Manual De Instrucciones página 15

6. Commissioning, operation
When a blow-out device is fitted to a pressure gauge, it must be
protected against being blocked by debris and dirt.
With safety pressure gauges (see dial symbol
space behind the blow-out back is at least 15 mm.
Requirements for the installation point
If the measuring point is not sufficiently stable a measuring instru-
ment support such as a bracket or flange should be used for fastening
(possibly via a flexible capillary). If vibrations cannot be avoided by
taking suitable measures during installation, liquid-filled instruments
should be used. Instruments must be protected against coarse dirt and
wide fluctuations in ambient temperature.
Installation
Nominal position per EN 837-1 / 9.6.7 Figure 9: 90° ( ⊥ )
„
Process connection lower mount (LM) or back mount (BM)
„
After mounting, set the compensating valve (if available) from
„
CLOSE to OPEN. The version of the vent
valve depends on the model and can deviate
from the illustration!
For outdoor applications, the selected installation location has to
„
be suitable for the specified ingress protection, so that the pressure
gauge is not exposed to impermissible weather conditions.
In order to avoid any additional heating, the instruments must not be
„
exposed to direct solar irradiation while in operation!
WIKA operating instructions pressure gauge, model 2 per ATEX
) ensure that the free
k
EN
15