aldes Dee Fly Instrucciones De Montaje página 36

TROUBLESHOOTING
Faults
Steady red fault warning
light
Blinking red fault light
Condensate leaks or water
noise in the heat exchanger
Low airflow levels at grilles
Cold incoming air supply
The motors are not working
RECYCLING
This product must not be thrown out with normal household waste.
At the end of its service life or when replaced it must be sent to a specialist collection
centre or back to a re-seller.
To the best of our knowledge, this article does not contain more than 0.1% by weight of
any substance requiring authorisation in compliance with the list of the 1st November 2008.
ALDES adheres to the 'Eco-Systemes' ecological organization www.ecosystemes.fr
Aldes has designed this product for easy recycling.
By participating in selective waste sorting, you are contributing to the recycling of this product and the protection
of our environment.
GUARANTEE
The unit is guaranteed for 2 years in accordance with our general terms and conditions of sale. The guarantee
takes effect from the date the product is purchased from the store with the invoice being proof of this date.
Causes
Clogged filters
Motor failure
Poor condensate evacuation
Network leaks
No auto-amplifier at the kit-
chen grille
Control panel
By-pass open
Power supply
36
Actions
Change the filters (see MAINTENANCE)
Change the faulty motor.
Contact your installer
Make sure the water trap has been instal-
led properly (see INSTALLATION)
If necessary, unblock the condensate eva-
cuation duct
Inspect the aeraulic network and sealing
Install the auto-amplifier behind the kit-
chen grille
Make sure the appropriate airflow rate has
been selected on the control panel,
depending on need (see PREPARATIONS
FOR INSTALLATION)
Make sure the by-pass is in good condition
and the motor is operating properly
Make sure the assembly is connected to
the mains