Trouble Shooting; Technical Specifications - Tennant MF32004 - F3 SINGLE DISC LS 230V/50HZ Manual Del Operario

Trouble Shooting

Problem
Machine does not operate
Machine operates with a wobbleor jerky
motion.
Machine circuit breaker trips continuously.

Technical specifications

A.C. motor
Rated power
Max.amp draw
Brush (rpm)
Brush (mm)
Working height (mm)
Working weight
Protection class
Belt- driven
Sound pressure level LPA
Weighted acceleration value
EC DECLARATION OF CONFORMITY FOR MACHINERY
EN
TENNANT N.V.
Address: Industrielaan 6 5405 AB
P.O. Box 6 5400 AA Uden- The Netherlands
Uden/Netherlands, 25- 1- 2010
Richard van den Hoogen -
Safety, Compliance, Documentation & Certification
F3/F3+/F8/F12 9002026 (07- 2013)
Cause
Faulty power cord.
Tripped circuit breaker
Faulty machine wiring.
Faulty motor.
Capacitor burned out.
Soiled Pad.
Improper pad/brush for application.
Pad driver/brush not installed correctly.
Pad/brush unevenly worn.
Pad not properly centered on pad driver
Heavily soiled pad/brush
Improper pad/brush for application
Defective circuit breaker.
Worn carbon brushes in motor.
F3 low speed
230 V: 50 Hz
1000 W
5,5 A
165
430
250
31 kg
lPx4
x
59db (A)
1.05 m/sec2
Model: F3, F3+, F8, F12
Herewith declares, on our own responsibility, that the machinery
- is in conformity with the provisions of the Machinery Directive (2006/42/EC), as amended
with national implementing legislation
- is in conformity with the provisions of the E.M.C. Directive 2004/108/EC.
and that
- the following (parts/clauses of) harmonized standards have been applied: EN ISO 14121- 1,
EN 1037, EN 60335- 1, EN 60204- 1, EN ISO 13849- 1, EN ISO 13849- 2, EN 60529, EN ISO 4413,
EN 349, EN 61000- 3- 2, EN 61000- 3- 3, EN 61000- 6- 2, EN 61000- 6- 3, EN 55014- 1, EN ISO 11201,
EN ISO 4871, EN ISO 5349- 1, EN ISO 5349- 2, EN 60335- 2- 67.
- the following (parts/clauses of) national technical standards and specifications have been used: NA
Solution
Contact Service Center.
Wait 10 min. till machine cooled down and
try again.
Contact Service Center
Contact Service Center
Contact Service Center
Replace Pad
Change to proper pad/brush
Remove and reinstall pad driver/brush
Replace pad/brush
Remove and reinstall pad driver
Clean or replace pad/brush
Change to proper pad/brush
Contact Service Center
Contact Service Center
F3+ low speed F8 high speed
230 V: 50 Hz 230 V: 50 Hz
1000 W 1100 W
5,5 A 5,5 A
165 400
430 430
250 250
43 kg 31 kg
lPx4 lPx4
x x
59db (A) 59db (A)
1.05 m/sec2 1.05 m/sec2
(Annex II, sub A)
English EN
F12 Duo speed
230 V: 50 Hz
1200/1500 W
5,2 / 8,1 A
170/340
430
250
37 kg
lPx4
x
65db
1.05 m/sec2
7