Trouble Shooting - Tennant 2100 Serie Manual De Operador Y Lista De Repuestos

EN OPERATION

TROUBLE SHOOTING

PROBLEM
Machine does not
operate.
Machine operates
with a wobble or jerky
motion. motion.
Machine circuit
breaker trips
continuously. continuously.
(2200/2260 models)
10
CAUSE
Faulty power cord.
Tripped circuit breaker. (2200/2260 Models)
Tripped building circuit breaker.
Faulty machine wiring.
Faulty On/Off lever switch.
Faulty motor.
The cord connection between the handle and
base is not correctly inserted.
Soiled Pad.
Improper pad/brush for application
Pad driver/brush not installed correctly.
Pad/brush unevenly worn.
Pad not properly centered.
Heavily soiled pad/brush.
Improper pad/brush for application.
Defective circuit breaker.
Home Find... Go To.. Home Find... Go To..
SOLUTION
Contact Service Center.
Reset circuit breaker on machine. Allow
machine to cool down for approximately
5–10 minutes.
Reset circuit breaker in building.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Ensure correct cord connection.
Replace Pad.
Change to proper pad/brush.
Remove and reinstall pad driver/brush.
Replace pad/brush.
Remove and reinstall pad.
Clean or replace pad/brush.
Change to proper pad/brush.
Contact Service Center.
2100/2120/2140/2150/2200/2260 (07–03)