Accessories; Disposal; Warranty; Eu Declaration Of Conformity - Festool CMS-TS-55-R Manual De Instrucciones

CMS-TS-55-R
GB
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
Maintain the machine regularly to make sure
it functions correctly:
Use an extractor to remove dust deposits.
Replace worn or damaged table inserts.
On completion of your work, wind the
power cable around the holders [12-9].
11

Accessories

Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under " ".
12

Disposal

Do not throw the power tool in your house-
hold waste! Dispose of machines, accesso-
ries and packaging at an environmentally re-
sponsible recycling centre. Observe the valid
national regulations.
EU only: European Directive 2002/96/EC
stipulates that used electric power tools must
be collected separately and disposed of at an
environmentally responsible recycling cen-
tre.
13

Warranty

We offer a warranty for material and produc-
tion defects for all our tools in accordance
with the locally applicable legal provisions,
but for a minimum of 12 months. Within the
EU member states, the warranty period is 24
months (verification through invoice or deliv-
ery note). Damage caused by the operator,
natural wear, overloading, incorrect handling
or through the use of the equipment not
specified in the operating manual, or damage
which was known at the time of purchase, is
16
not covered by the warranty. Furthermore,
damage caused by the use of non-original
accessories and consumable materials (e.g.
sanding pads) is also excluded.
Complaints can only be accepted if the tool is
returned while still assembled to the supplier
or an authorised Festool Customer Service
workshop. Keep the operating manual, safe-
ty instructions, spare parts list and purchase
receipt in a safe place. Otherwise the current
warranty conditions of the manufacturer
shall apply.
Note
Due to continuous research and develop-
ment work, we reserve the right to make
changes to the technical content of this doc-
umentation.
14 EU Declaration of Conformi-
ty
Retaining panel for por-
table circular saws
CMS-TS-55-R
We declare under sole responsibility that this
product complies with the following direc-
tives and standards:
2006/42/EG, 2004/108/EG,
(from 01.01.2013), EN 60745-1, EN 60745-
2-5, EN 55014-1, EN 55014-2, EN 61000-3-
2, EN 61000-3-3.
Festool GmbH
Dr. Johannes Steimel
Head of Research, Development and Techni-
cal Documentation
REACh for Festool products, its
accesso-ries and consumable
materials:
REACh is a European Chemical Directive that
came into effect in 2007. As "downstream us-
ers" and product manufacturers, we are aware
of our duty to provide our customers with in-
formation. We have set up the following web-
site to keep you updated with all the latest
news and provide you with information on all
the materials used in our existing products:
Serial no.
10002996
2011/65/EU