Original Operating Manual 1 Symbols; Items Included; Technical Data; Intended Use - Festool CMS-TS-55-R Manual De Instrucciones

CMS-TS-55-R
GB
Original operating manual
1 Symbols..................................
2 Items included .........................
3 Technical data..........................
4 Intended use ...........................
5 Safety instructions ...................
6 Assembly ................................
7 Power supply and start-up .........
8 Settings ..................................
9 Working with the machine .........
10 Service and maintenance ..........
11 Accessories .............................
12 Disposal..................................
13 Warranty.................................
14 EU Declaration of Conformity .....
The illustrations specified are located at the
beginning and end of the operating manual.
1 Symbols
Warning of general danger
Risk of electric shock
Read the Operating Instructions/
Notes!
2

Items included

[1-1] Cutting depth adjuster
[1-2] Switch-on clip
[1-3] Flange bolt
[1-4] Scales/rulers
[1-5] Retaining panel for portable circular
saws
[1-6] Protective cover
[1-7] Protective cover bracket
[1-8] Push stick
[1-9] Preset profile setting rail
3

Technical data

Module mounting /
retaining panel
Inclination
Cutting depth at 0°
Cutting depth at 45°
Weight
12
12
12
12
12
12
13
15
15
15
15
16
16
16
16
CMS-TS-55-R
0° to 45°
0 - 51 mm
0 - 38 mm
3,3 kg
4

Intended use

The following Festool plunge-cut saws can be
installed in the CMS-TS-55-R retaining pan-
el:
- TS 55 REBQ, TS 55 REQ, TS 55 RQ
The installation of other portable circular
saws is not possible and therefore not per-
mitted.
Fit one of the above-mentioned portable cir-
cular saws to the retaining panel and install
it in the CMS-GE to form a mobile bench-
mounted circular saw.
Plunge-cut saws are intended to be used for
sawing wood, materials similar to wood,
plaster and cement-bonded fibre materials
and plastics. When fitted with special saw
blades for aluminium offered by Festool,
these machines can also be used for sawing
aluminium.
WARNING
The user will be liable for damage due
to improper use.
5 Safety instructions
5.1

General safety instructions

WARNING Read all safety warnings
and all instructions provided with
the working stand and the power tool to
be mounted. Failure to follow the warnings
and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool
or battery-operated (cordless) power tool.
- Keep all of the attached documents
and pass on the documentation if the
machine changes ownership.
- Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any ad-
justments or changing accessories.
Accidental starting of the power tool is a
cause of some accidents.
- Properly assemble the working stand
before mounting the tool. Proper as-