Dust Extraction - Festool CMS-TS-55-R Manual De Instrucciones

CMS-TS-55-R
GB
6.2 Installing the portable circular
saw in the retaining panel [1-5]
Turn the saw retainer over and position in
the opening on the CMS-GE.
Unscrew the rotary knobs on both retain-
ers [5-3] + [5-6].
Slide the movable retainer [5-3] as far
outwards as possible.
Insert the portable circular saw in such a
way that the saw base rests against the
fixed retainer [5-6].
Adjust both jaws [5-5] until the portable
circular saw is sitting on the guide groove
[5-4] on the retaining panel and there is
no play.
Slide the movable retainer [5-3] up to
the stop on the portable circular saw
base.
Tighten the rotary knobs on both retain-
ers [5-3] + [5-6].
The portable circular saw should now be se-
curely fixed to the retaining panel. Check
this before continuing assembly.
6.3 Joining the protective cover
bracket [1-7] to the guide
wedge
Unscrew the locking knob [5-2] for cut-
ting depth adjustment.
Push down the portable circular saw until
the cutting depth indicator [5-1] shows
approx. 20 mm.
Tighten the locking knob [5-2].
Slide in the protective cover bracket [6-
1] onto the guide wedge [6-2] until the
holes are aligned with the opening [6-4]
on the plunge-cut saw.
Insert the flange bolt [6-3] through the
hole to attach the two parts together.
The protective guard bracket must be joined
securely to the guide wedge. Check this be-
fore continuing assembly.
6.4 Securing the switch-on clip [1-
2]
Slide the switch-on lock [7-3] on the por-
table circular saw forwards.
14
Slide the switch-on clip [7-1] over the
ON/OFF switch [7-2] on the portable cir-
cular saw.
The on/off switch is now pressed down con-
tinually. Once installed, the portable circular
saw is switched on and off via the switch/
connector unit on the CMS-GE.
Important: The electronic brake on
the TS 55 REBQ is deactivated when-
ever the ON/OFF switch on the porta-
ble circular saw is pressed down con-
tinually.
6.5 Installing the retaining panel in
the basic unit CMS-GE
Insert the retaining panel in the basic unit
CMS-GE the correct way round (see Fig.
[8], Switch/connector unit [8-1] on the
left side). Grasp the retaining panel by the
recesses [8-2].
Close the two locks [8-3], clockwise).
6.6 Securing the protective cover
[1-6]
Secure the protective cover by screwing
the rotary knob [9-2] into the hole on the
protective cover bracket [9-1].
6.7 Scale for cutting width [1-4]
Use the screws to secure the two rulers
[10-1] at the feed end of the basic unit.
Align the scales on the rulers so that the
zero points line up with the left and right
cutting edges of the saw blade.
6.8

Dust extraction

WARNING
Dust hazard
Dust can be hazardous to health. Always
work with a dust extractor.
Always read applicable national regula-
tions before extracting hazardous dust.
The CS 70 AB extractor set is available as an
accessory and includes adapters for connect-
ing the saw unit to a Festool mobile dust ex-
tractor. The extractor set allows the user to
simultaneously extract dust and chips both
at the portable circular saw (dia. 36 mm) and
the protective cover (dia. 27 mm).