Cleaning The Chip Ejection Opening; Accessories; Sawing With Special Base Runners; Sawing With The Angle Table - Festool CARVEX PSC 420 EB Manual De Instrucciones

Keep the contacts on the power tool, charg­
er and battery pack clean.

10.2 Cleaning the chip ejection opening

Clean the chip ejection opening [1-14] regularly
to prevent blockages:
► Remove the chip guard.
► Use a brush or vacuum cleaner to clean the
chip ejection opening.
► Reinsert the chip guard.

11 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".
11.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations that are specially designed for your
Festool jigsaw.

11.2 Sawing with special base runners

The special base runners protect high-quality
surfaces against scratches and scores.
► Press in the base runner at position [6-1].
► At the same time, push the base runner for­
wards.
► Mount another base runner and push it to
the rear until it engages.

11.3 Sawing with the angle table

The WT-PS 400 angle table is used for
cutting pipes or interior and exterior an­
gles up to 45°.
Dust extraction is not possible when sawing
with the angle table!
Installing the angle table
► Remove the saw table [1-11] (see section
8.4 ).
► Position the angle table against the saw
base support.
► Close the lever [1-9].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
► Turn the adjusting wheel [7-1] to select the
required angle.
You can select the angles -45°, 0° and +45° on
the scale [7-2].
WARNING
Sawing cutting depths
Risk of injury
► Select the saw blade length and cutting
depth so that the saw blade remains
plunged in the workpiece.
For 0° cuts, we recommend setting the an­
gle table to a small negative angle to guar­
antee smooth operation.

11.4 Sawing with the base adapter

The ADT-PS 400 base adapter is used for at­
taching your jigsaw to the Festool guide rail and
the KS-PS 400 core maker.
With guide rail and core maker: Observe
the max. material thickness of 20 mm
and only use cross-set saw blades (FSG).
Installing the base adapter
► Remove the saw table [1-11] (see section
8.4 ).
► Position the base adapter [8-1] against the
saw table support.
► Close the lever [1-9].
Ensure that the base adapter is firmly seated in
the guide.
Also use the extractor connector [1-8]
with the base adapter.
Adaptation to the FS 2 guide rail
The FS 2 Festool guide system (Fig. [9]) makes
it much easier to produce straight and precise
cuts.
► Place the jigsaw with attached base adapter
[8-1] on the guide rail.
Adaptation to the core maker
The core maker can be used to create circular
cuts with a diameter between 120 and
3000 mm. The core maker can be installed from
both sides on the base adapter.
► Place the jigsaw with attached base adapter
on the adapter [10-1] on the core maker.
► Insert the centring mandrel [10-2] in the
hole [10-4] on the core maker aligned with
the saw blade.
► Clamp the measuring tape to the core mak­
er using the rotary knob [10-5].
Recommended settings when using the core
maker:
► Cut in an anticlockwise direction.
► Work at a slow rate of advance.
► Set the pendulum stroke [1-12] to 0–1.
English
21