Machine Identification Data; Safety Warnings - S&P HIB Manual De Instalacion Y Uso

1.2 STORING THE OPERATING INSTRUCTIONS
This Operating Instructions Manual is a passive safety device; therefore, it is
obligatory to keep a copy of it throughout the whole life cycle of the machine.
Operators and technical maintenance staff should be able to quickly refer to this
document.
CONTROL UPON RECEIPT
1.3
The machine must arrive safely packaged and in perfect condition. Despite
careful procedures, it is possible that the packaging and/or its contents may be
damaged during shipping. It is recommended that all units are examined at the
time of receipt in order to check for visible damages.
If any damages are identified, contact S&P in order to establish how to proceed.
S&P reserves the right to carry out their own inspection.
Check also that the received machine identification data matches exactly the
information in your order.
1.4

MACHINE IDENTIFICATION DATA

The identification plate with the EC mark is located on the metallic structure, on
the intake side. The plate specifies the S&P identification data, the model, the
serial number and the year of manufacture, as well as the specific technical
data of the industrial extractor.
2

SAFETY WARNINGS

WARNING: SOLER & PALAU Sistemas de Ventilación S.L.U. (S&P) shall
not be liable for damage to the machine and/or injury to personnel resulting
from failure to comply with the safety guidelines set forth in this Manual.
WARNING: It is very important to adhere to and respect the safety instructions.
Non-compliance may cause personal injury and/or damage the machine.
WARNING: The air extractor should be installed and periodically maintained
only by authorised qualified personnel, since they are trained to carry out the
necessary operations and they are aware of the safety standards in force in the
country of installation.
16