S&P HIB Manual De Instalacion Y Uso página 18

WARNING: The purpose of the pictograms is to inform the user about the risks derived
from the rotary movement of and the inlet caused by, the impeller blades. They play an
important role in passive safety. It is strictly forbidden to remove them.
3 SAFETY AND INSTALLATION ACCESSORIES
3.1 HIT / HIB SAFETY KIT
Metallic safety guard meshes have been installed to guarantee a sufficient level
of safety against accidental contact with the moving parts of the machine.
Although all standard models leave the factory with the interior metallic guard
mesh (Figure 1-A), it is possible to order upon request the S&P HIT / HIB safety
kit (exterior metal guard mesh) to protect the exterior (Figure 1-B).
NOTE: If the base of the fan is at a height of a minimum of 2.7m from the floor,
then it is not necessary to use the exterior metallic mesh guard, although it is
recommended.
3.2 HIT / HIB WALL-MOUNTING KIT
To correctly install the extractor on the wall, you can use the S&P mounting
profiles (Figure 2). These profiles attach to the interior part with M8 screws, to
the sides of the machine, where threaded holes are located for that purpose.
3.3 HIT / HIB LIGHT-BLOCKING KIT
The S&P light-blocking screens can be attached to the interior part to prevent
light from entering. Especially suitable for poultry farms (Figure 4).
3.4 HIT / HIB INSULATING COVER KIT
Should it be necessary to take an extractor out of service or to keep it inactive for
a long period of time (for example, in winter), and to avoid heat loss and/or air
currents, make use of the S&P insulating covers (Figure 11).
NOTE: All these safety / assembly accessories are supplied separately and upon
request. Consult our catalogue or visit our website www.solerpalau.com and
contact our official distributor.
4 PRELIMINARY INSTALLATION
NOTE: The operations indicated below must be exclusively performed before
wall-mounting or before proceeding to the installation in the machine housing.
WARNING: The extractor installation and maintenance procedures must only
be performed by adequately trained personnel.
Take the rubber cable grommet located in the bag with the Operating
Instructions Manual and manually place it into the opening located on the side,
as indicated in Figure 5.
18