Parts And Components; Assembly; Tools Needed - WAGNER CONTROL PRO 130 POWER TANK Manual Del Propietário

PARTS AND COMPONENTS

Tank
Spray hose
port

ASSEMBLY

Do not plug in the power cord until assembly is
complete.
i Remove the plastic cap from the spray hose port and
the plastic plug from the end of the spray hose prior to
assembly.

TOOLS NEEDED

•
Two 6" adjustable wrenches
1.
Thread one end of the high pressure spray hose to the spray hose
port. Hold the port with an adjustable wrench, and tighten the hose
with the other. Do not over-tighten.
If you purchased the accessory hose (sold separately),
i
make sure to attach this accessory hose first to the
pump (the same way as step 1, above). Then attach the
hose included with the sprayer to the accessory hose.
2.
Spin the gun onto the male fitting on the other end of the spray hose.
Turning the gun instead of the hose will make it easier to align the
threads. Tighten the hose end with a wrench.
6
A
Tank lid
k
B
Inlet filter (A)
Material
return tube
ON/OFF
switch
The PRIME/SPRAY
knob can be turned
PRIME/SPRAY
in either direction to
knob (B)
desired setting
(vertical = PRIME,
horizontal = SPRAY).
1
2
EN
Spray hose
Spray gun
Spray tip
PRIME
p
Tip guard
SPRAY
Washer (a) and
saddle seat (b)
come preassembled
inside the spray guard
a
b