Babytalker 3000 SEDS
8
Initial use
8.1
Package contents
The equipment is supplied as standard with the following items:
- 1 baby unit
- 1 parent unit
- 1 charging station
- 2 AC mains adapters
8.2
Installing batteries in the baby unit
•
You can operate the baby unit with three AA cells (LR06/penlight; we recommend alkaline
cells) or using the AC mains adapter included.
•
The baby unit cannot recharge batteries.
•
It is recommended that the batteries always be left in the unit, even if you use the AC mains
adapter. The unit will automatically switch to battery power in case of a mains power failure.
•
Never mix used cells with fresh cells.
– Rotate the belt clip
– Turn the screw on the cover of the battery compartment
baby unit 90° counterclockwise and remove the battery compartment cover.
•
Do not turn the screw past the 'OPEN' point.
– Fit three AA alkaline cells (LR06/penlight) in the battery compartment.
Ensure that the polarity is correct.
– Close the battery compartment.
•
The red On/Off LED
exhausted. Recharge the batteries.
8.3
Connecting the baby unit to the AC mains
Insert the small plug of the AC mains adapter in the mains power
connector of the baby unit
into a mains socket (230 V / 50 Hz).
CAUTION
•
The mains socket must be within easy reach so you can
quickly unplug the power cable in an emergency.
•
Use only the AC mains adapter supplied
(6 V DC / 300 mA – Type KSS05-06-0300G).
8.4
Installing rechargeable batteries in the parent unit
CAUTION
•
Use only the NiMH battery pack supplied in the parent unit.
– Rotate the belt clip
– Turn the screw
the back of the parent unit 90° counterclockwise and remove the battery
compartment cover.
•
Do not turn the screw past the 'Open' point.
– Place the NiMH battery pack in the battery compartment.
Ensure that the tab of the battery pack (A) fits into the matching recess
upward.
9
will flash once the battery pack is
2
and plug the AC mains adapter
8
upward.
20
located on the cover of the battery compartment at
21
- 1 user guide
- 1 service card
- 1 NiMH rechargeable battery pack
at the back of the
7
SEDS
LONG
ECO
OPEN
SEDS
1
x
A
A
LONG
6V/300mA
+
-
ECO
1
x
A
A
6V/300mA
OPEN
B
A
+
5