Connecting The Baby Unit To The Ac Mains; Initial Use - Topcom BABYVIEWER KS-4240 Manual De Usuario

®
7.1 Baby unit components
See Figure on the fold-out page.
A
1 On/off LED
2 Night light LED
3 Infrared LED for night
vision
4 On/off switch
5 Lens
6 Microphone
7 Wall mounting cavity
7.2 Parent unit components
See Figure on the fold-out page.
B
14 Volume LED
15 Microphone
16 Increase volume /
Next menu item
17 Decrease volume /
Previous menu item
18 Music button
19 Camera button
20 2,4" (6,1cm) colour display
21 Link LED
7.3 Display description
Out of range or no
connection
Volume icon
Melody icon
8

Initial use

8.1 Package content
The equipment is supplied as standard with the following items:
- 1 baby unit
- 1 parent unit
- 2 AC mains adapters
8.2 Installing batteries in the baby unit
• You can operate the baby unit with 4 AAA
cells (LR03; we recommend alkaline cells)
or the included AC mains adapter.
• The baby unit cannot recharge batteries.
• It is recommended to always leave the
batteries in the unit, even if you use the AC
mains adapter. The unit will automatically
switch to battery power in case of a mains
power interruption.
– Turn the screw on the cover of
the battery compartment at
the back of the baby unit 90°
counter clockwise and remove
the battery compartment
cover.
Do not turn the screw past the "OPEN" point.
4
8 Crib connector nut
9 Light sensor
10 Pair button
11 Speaker
12 Connector for AC mains
adapter
13 Room temperature sensor
22 Power on/off LED
23 Menu button
24 Push to Talk button
25 On/off button
26 Belt clip
27 Speaker
28 Charging dock
LCD display
brightness icon
Temperature unit
C
icon
Night light icon
- 1 user guide
- 1 Li-ion rechargeable battery pack
OPEN
90° MAX
Babytalker 3500 SEDS
– Fit four AAA alkaline
cells (LR03) in the
battery compartment.
Ensure that the polarity is
correct.
– Close the battery
compartment.
Never mix used cells with fresh cells.
8.3

Connecting the baby unit to the AC mains

Insert the small plug of the
AC mains adapter in the
mains power connector of
the baby unit and plug
12
the AC mains adapter into a
mains connector (100~240
V - 50/60 Hz).
CAUTION
The mains connector must be within easy reach so you
•
can quickly unplug the power cable in an emergency.
Use only the supplied AC mains adapter (5.9 V DC /
•
800 mA).
8.4 Installing the rechargeable battery pack in
the parent unit
CAUTION
• Use only the supplied Li-ion battery pack in the parent
unit.
– Rotate the belt clip
– Open the battery compartment an place the Li-ion
battery pack
– Carefully close the battery compartment and rotate the
belt clip back downwards.
8.5 Connecting the parent unit to the AC mains
– Connect the adapter for the charging dock to the mains
(100~240 V - 50/60 Hz). Place the parent unit on the
charging dock.
It takes around 10 hours to fully charge the
batteries.
upward.
26