Other Information; Troubleshooting - Sony FWD-S42E1 Manual De Instrucciones

Other Information

Troubleshooting

Check whether the 1 indicator is flashing red.
When it is flashing
The self-diagnosis function is activated.
1 Check how many times the 1 indicator flashes and how long it stops flashing.
For example, the indicator flashes 2 times, stops flashing for 3 seconds, and flashes 2 times.
2 Press 1 button on the display and the main power switch to switch off the power, then disconnect the
AC power cord.
Inform your dealer or Sony service center of how the indicator flashes (the number of flashes and the duration
of light out).
When it is not flashing
1
Check the items in the table below.
2 If the problem still persists, have your display serviced by qualified personnel
Problem Possible Remedies
The power button and control
• Check "Control Setting" (page 26).
buttons on the display do not work.
The power will not come on even if • Check that the main power switch is not turned "OFF." (page 11)
the 1 button is turned ON, or the
ON button on the remote control is
turned ON.
No signal is output from the HD- • There is no HD-SDI OUT output when this device is in standby
SDI OUT connector of the BKM- status or the AC power supply is switched off.
FW16.
No picture.
No picture. • Check the connection between the video equipment and the display.
• Check the settings of "RGB/YUV" (page 27).
• Try switching input using the INPUT button of the display, or the
remote control (page 11, 13).
The display turns off • Check if "Timer Setting" is activated (page 26).
automatically. • Check if the "Auto Shut Off" function is set to "On" (page 27).
• Check if the room temperature is above 40°C.
Poor picture.
No color/Dark picture/The • Press PICTURE button to select the desired "Picture Mode" (page 13).
picture is too bright/Color is not
• Adjust the "Picture Mode" options in the "Picture/Sound" settings
correct/The picture gradually (page 22).
becomes dark/Horizontal noise • Check the condition of the signal cable.
appears on the picture • Check if the room temperature is above 40°C.
• Check the settings in "ECO mode." (page 26)
The whole screen is tinged • Check whether the "RGB/YUV" settings are incorrect (page 27).
green or purple.
No sound/Noisy sound.
Picture displayed, no sound. • Check the volume control.
• Press
Muting disappears from the screen (page 14).
• Check "Speaker Out" settings (page 26).
32
GB
button on the remote control or + button so that