Epson SureColor S Serie Guia De Instalacion página 26

| Adjusting the Take-in Reel
24
Lift up the alignment tool and slide it to the other side of the printer, next to the right adjustment
13.
guide. Line up the alignment tool and the adjustment guide at the front and back of the printer.
Note the location where the alignment tool crosses the front of the white line on the platen. If the
location is different from the left side, go to step 14. If they are the same, go to step 15.
Make sure all four of the mounting screws are loose. To make adjustments, have a person at the back
14.
of the printer turn the silver adjustment screw. Turn the screw counterclockwise to move the line
back, and turn it clockwise to move the line forward. The line will move approximately 1 mm with
each turn of the screw. Continue to turn the silver adjustment screw until the measurements are the
same.