Epson SureColor S Serie Guia De Instalacion página 32

| Adjusting the Take-up Reel
30
Lift up the alignment tool and slide it to the other side of the printer, next to the right adjustment
6.
guide. Line up the alignment tool and the adjustment guide at the front and back of the printer.
Note the location where the alignment tool crosses the front of the white line on the platen. If the
location is different from the left side, go to step 7. If they are the same, go to step 8.
Make sure all four of the mounting screws are loose. To make adjustments, turn the adjustment screw
7.
counterclockwise to move the line back, and turn it clockwise to move the line forward. The line will
move approximately 1 mm with each turn of the screw. Continue to turn the silver adjustment screw
until the measurements are the same.