Sd Card Installation; Capacity Label Instructions - Mettler Toledo IND246 Guia De Instalacion

SD Card Installation

The SD memory card can be used for additional storage in the Checkweighing and
Counting applications, and must be installed if the Vehicle Application is used.
Figure 2-33 shows the installation of an SD card into the socket on the edge of the
IND246 main board.
Figure 2-33: Sliding an SD Card into the SD Socket (left); SD Card Installed (right)

Capacity Label Instructions

The regulations in some locations require that the scale capacity and increment be
shown on the front of the terminal, near the display. To satisfy this requirement, a
blue capacity label is included with the terminal that must be completed and
adhered to the front overlay.
The capacity label (shown in Figure 2-34) provides space for the Max, min, and e
information for both ranges for which the scale is programmed. If only one range is
used, the unused portion of the label may be cut off with scissors. Written
information must be legible and a minimum of 2mm or 0.08 in. in height. A
permanent marker should be used for this information.
Clean any oil or other contaminants from the area of the overlay shown in Figure
2-35 where the capacity label will be added. Peel the backing from the label and
adhere it to the overlay in the location shown in Figure 2-35, or another location
acceptable to the local regulations.
IND246 Terminal Installation Manual
Figure 2-34: Preparing the Capacity Label
2-21