Anti-Motion Level; Communication Setup; Communication On/Off; Baud Rate - Baxtran STA Serie Manual De Usuario

STA/STR/STC
The default display frequency

ANTI-MOTION LEVEL

At the cost of measuring time,
scale is in motion. The weaker
takes to settle the weight reading.
There are optional 6 levels of anti-motion, "0", "1", "2", "3", "4", "5", respectively "Off", "weakest",
"weak", "normal", "strong", and "strongest".
The default anti-motion level
NOTICE:
High resolution offers better accuracy at the cost of longer measuring time and stricter
requirement of load's stability. Designed to meet the OIML R76's directive, this scale has
the best (default) performance at 2000 to 3000 division.

COMMUNICATION SETUP

ACTION
To enter COMMUNICATION SETUP MODE, press
To input digits, press
To confirm input value, press
To save and exit
ller.
To exit communication setup mode
controller.
To learn how to input digits or change the option, please refer to 5 User Input section.
FUNCTION
In communication setup
receiver's requirement, like communication on/off status, baud rate, scale communication address,
signal output mode, etc.
The screen displays the welcome message as below
CONDITION
The scale must not be in

COMMUNICATION ON/OFF

The scale's serial communication port is controlled by the
port is set to be on, the scale enables its serial communication, while port is off, communication is
disabled.
communication on/off
By default, the

BAUD RATE

Baud rate is the speed that scale output signal. There are optional 4 baud rates: 1200bps, 2400bps,
4800bps, and 9600bps.
By default, baud rate
is set to level "1".
anti-motion
anti-motion
is set to "2", namely "normal".
ZERO and TARE button on scale or
HOLD
button on scale or
communication setup
without saving, press ON/OFF button on scale or
mode, user can change the scale's serial communication manner to meet the
HOLD mode. Otherwise, error message
status is set to off.
is set to 1200bps.
function intelligently settles the weight reading when the
is, the faster weight reading displays, but the longer it
and on remote controller.
F2
and
on remote controller.
mode, press 2ND
button on scale for
communication on/off
User's Guide
on remote controller.
on remote contro-
on remote
will keep flashing.
status. When the
47