Special Tools; Inflation - SICE M 39 ATV Manual De Instrucciones

- After mounting the lower bead , repeat the same procedure for the upper bead.
- Turn the swing arm outward, free the wheel and inflate the tyre.

Special Tools

For wheels smaller than 8'' a special mounting roller is available
on request (see accessories available on request).
Wheels from 5'' to 8''
To mount wheels with a diameter up to 8'', use the roller (R
Fig 5) (optional). Place the central pivot of the roller on the
edge of the rim and block it with the handle M fig 5. Press the
pedal F Fig.5 to start clockwise turning and mounting.
Use the rim groove by pressing on the tyre wall to reduce the
torsional strength on the bead during rotation. (Fig.11)
WARNING
Tyre inflation is a dangerous operation. Always inflate tyres in the strictest observance of the following instructions.
ATTENTION
During this stage of operation, noise levels of 70 dB(A) may be present.
We recommend that the operator wears hearing protectors.
WARNING
During the bead insertion and inflation procedure, safety goggles and ear protection must be worn.
DANGER
The machine, even if it limits pressure, does not provide sufficient protection against exploding tyres during inflation.
Failure to observe the following instructions will make tyre inflation extremely dangerous.
DANGER
NEVER exceed the maximum pressure stipulated by the tyre manufacturer.
If inflated beyond this limit, tyres are liable to explode.
KEEP THE HANDS AND BODY WELL CLEAR OF THE TYRE DURING INFLATION.
Make sure you are well concentrated during this stage of operation and make frequent checks on the tyre pressure to
avoid the risk of excess inflation.
Exploding tyres can cause serious injury or death.
- Release the wheel from the table top jaws.
- Connect the Doyfe inflator check on the air hose to the valve stem.
- Inflate the tyre with small blasts of air. Never exceed the maximum pressure specified by the tyre manufacturer.
M 39 ATV

INFLATION

Inflation
32
ENGLISH • Instructions manual
11