Know Your Product; Operation; Prior To Initial Operation - SPARKY BU 130 Instrucciones De Uso

whenever possible.
machine or upon jamming the drill bit.
during operation and immediately after that;
they may be extremely hot. You may get seri-
ous burns.
particularly dangerous. Dust from light alloys
can burn or explode.
never be left around the work area.
it down.
purpose. Any use other than those mentioned
in this Manual will be considered a case of
misuse. The user and not the manufacturer
shall be liable for any damage or injury result-
ing from such cases of misuse.
the safety regulations, the assembly instruc-
tions and the operating instructions found in
this Manual. All persons who use and service
the machine have to be acquainted with this
Manual and must be informed about its poten-
tial hazards. Children and frail people must not
use this tool. Children should be supervised
at all times if they are in the area in which the
tool is being used. It is also imperative that
you observe the accident prevention regula-
tions in force in your area. The same applies
for general rules of occupational health and
safety.
changes made to the tool nor for any damage
resulting from such changes.
rainy weather, or in moist environment (after
liquids and gases. The working place should
be well lit.

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Securing screw (BUR 130E)
2. Chuck
6
EN
4. Drill journal
5. Operation mode selector switch
6. Ventilation slots
7. Depth gauge
8. Auxiliary handle
9. Reversing switch (BUR 130E)
10. Electronic regulator of rotation speed
(BUR 130E)
12. Lock-on button

Operation

This power tool is supplied from single-phase
alternating current mains only. It is double in-
sulated according to EN 60745-1 and IEC 60745
and can be connected to grounded or not
grounded sockets. This power tool is radio sup-
pressed in compliance with EMC Directive.
These power tools are designed for drilling in
concrete (or various brittle materials), steel,
wood, etc.

PRIOR TO INITIAL OPERATION

sponds to the value indicated on the name
plate with technical data of the tool.
The power tool must be connected to the
power supply socket only when this switch is
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and
unplug the power tool prior to any adjustment,
servicing or maintenance.
er source, use as short as practicable exten-
sion cord with proper cross-section.
mounted and reliably tightened.
-
-