Intended use
PondoClear Set 4000, referred to as "unit", may only be used as specified in the following:
For cleaning garden ponds.
Only operate with water at a water temperature of +4 °C to +35 °C.
Operation under observance of the technical data.
The following restrictions apply to the unit:
Do not use in swimming ponds.
Never use the unit to convey fluids other than water.
Never run the unit without water.
Do not use for commercial or industrial purposes.
Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Safety information
Hazards to persons and assets may emanate from this unit if it is used in an improper manner or not in accordance
with its intended use, or if the safety instructions are ignored.
This unit can be used by children aged 8 and above and by persons
with reduced physical, sensory or mental capabilities or lack of expe-
rience and knowledge if they are supervised or have been instructed
on how to use the unit in a safe way and they understand the haz-
ards involved.
Do not allow children to play with the unit.
Only allow children to carry out cleaning and user maintenance under
supervision.
Hazards encountered by the combination of water and electricity
The combination of water and electricity can lead to death or severe injury from electrocution, if the unit is incorrectly
connected or misused.
Prior to reaching into the water, always switch off the mains voltage to all units used in the water.
Correct electrical installation
Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
A person is regarded as a qualified electrician if, due to his/her vocational education, knowledge and experience, he or
she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the recog-
nition of possible hazards and the adherence to the pertinent regional and national standards, rules and regulations.
For your own safety, please consult a qualified electrician.
The device may only be connected if the electrical data of the device and the power supply coincide. The device data
is to be found on the device type plate, on the packaging or in this manual.
Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).
Only connect the unit to a correctly fitted socket.
Safe operation
Never operate the unit if either the electrical cables or the housing are defective!
Do not carry or pull the unit by its electrical cable.
Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
Only use original spare parts and accessories for the unit.
Never carry out technical modifications to the unit.
A damaged connection cable cannot be replaced. Dispose of the unit.
Only operate the unit if no persons are in the water.
Keep the socket and power plug dry.
- EN -
13