GE IM6 Manual Del Propietário página 47

ICEMAKER INSTALLATION INSTRUCTIONS P
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1 PREPARE FOR INSTALLATION
• Remove and discard the large white plug from
the rear freezer wall. Pull out the gray insulation
plug and remove any debris.
• Remove the two small white plug buttons on the side
wall. Install two Phillips head screws (14) in the holes
that the plug buttons were in, but do not screw them
all the way in. The screw heads should extend about
1/2" (13 mm) from the side wall of the freezer.
• Remove the outlet cover with a flat-blade
screwdriver.
14
Installation Instructions
Unplug the
Pliers Sharp knife
C F G H J K L
2
INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
on page 66) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Go to the back of the refrigerator. In the upper right
hand corner, remove the label covering the hole. Pull
out the insulation plug and any debris.
• On the tube side of the
water tube inlet (15) there
is an adhesive backing.
Remove the adhesive
backing and slide the
tube into the hole near
the top at the back of the refrigerator. Firmly press
on the inlet to secure it to the refrigerator.
3
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
46
or T
M N P Q R S
P
template
P
15
(Appearance may vary)
16
Hole for
wire tie