Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS H
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdriver
1
ATTACH THE WATER VALVE
• Locate the female connector plug (B).
Installation Instructions
Unplug the
Pliers
Sharp knife
B
C
F
G
H
J
K
L
• Plug the female connector (B) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet edge hole
using the hex-head screw (13) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
• Check the plastic water line nut on the bottom of
the water valve to be sure it is hand tight. DO NOT
USE TOOLS.
INSTALL WATER LINE CLAMP
2
• Attach the metal water line clamp (strain relief)
(8) to the refrigerator. Drive the screw (7) from the
kit through the clamp (8) at the indent into the
back of the cabinet.
• The metal clamp is for the house water line (see
the Water Line Installation Instructions). It is not
to be used for the tubing from the water valve up
to the icemaker.
24
or T
M
N
P
Q
R
S
B
4
13
7
8
Publicidad
Tabla de contenido
