GE IM6 Manual Del Propietário página 29

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS J
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger of
electric shock during installation, you
must unplug the refrigerator from its
electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" Nutdriver
REMOVE THE ACCESS COVER
1
Remove the rear access cover. This requires
removing six screws which attach the cover to the
back of the refrigerator case. Use a 5/16" socket or
an adjustable wrench. Be sure to save the screws as
the access cover must be reinstalled later to ensure
your refrigerator will function properly.
Installation Instructions
Unplug the
Sharp knife
Pliers
5/16" Socket or adjustable wrench
C F G H J K L
2
ATTACH THE WATER VALVE
• Locate the female connector plug (A).
• Plug the female connector (A) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet by driving
the hex-head screw (13).
DO NOT DRILL ANY ADDITIONAL HOLES
NOTE: There may be some internal refrigerant
tubing that will need to be moved slightly in order
to provide enough room to install the water valve.
• Check the plastic water line nut on the bottom
of the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
28
or T
M N P Q R S
A
A
4
13