GE IM6 Manual Del Propietário página 49

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS P
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
1 REMOVE THE COVER
Remove the screws holding the left side of the
compressor cover and save them for reinstallation
later. Bend the cover back to access the
compartment.
Installation Instructions
Unplug the
Sharp knife
Pliers
C F G H J K L
ATTACH THE WATER VALVE
2
• Locate the female connector plug (B). If there
are 2 female connectors, use the colored one.
Plug the female connector (B) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet by inserting
the bracket hook on the left inner side of the
compressor compartment. Drive the hex-head
screw (13) from the kit through the hole in the
bracket into the hole on the cabinet.
INSTALL WATER LINE CLAMP
3
Attach the water line clamp (strain relief) (8) from
•
the kit to the refrigerator. With the clamp directly
in line with the water valve, drive the screw (7)
from the kit through the clamp (8) at the indent
into the back of the cabinet.
The metal clamp is for the house water line (see
•
Water Line Installation Instructions). It is not to be
used for the tubing from the water valve up to the
icemaker.
48
or T
M N P Q R S
B
4
13
7
8