GE IM6 Manual Del Propietário página 66

5
REMOVE THE TUBE COVER
• At the bottom right rear of the refrigerator, remove the
screws holding the tube cover (A) to the case back.
• Remove the cover to gain access to the water tube
inlet.
• Be sure to save the screws, as the tube cover must
be reinstalled after the water line has been
connected to the water tube inlet.
6
CONNECT THE WATER LINE
• Remove the small plastic cap (B) from the bottom of
the water tube inlet located behind the tube cover.
• Squeeze the ends of the hose clamp (6) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Installation Instructions
A
Water tube
inlet
6
B
65
ROUTE AND ATTACH THE PLASTIC
7
WATER LINE
Fasten the plastic water line to the back of the
•
cabinet with adhesive-backed fastener (5).
WATER VALVE INSTALLED
8
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
Adhesive-backed fastener
for plastic water line