Welding; Putting Out Of Operation - Rothenberger ROWELD P 160 B Instrucciones De Uso

CAUTION! Do not touch the trimmed, ready to weld surfaces. Ensure that the surfaces
are free of any and all containments and foreign objects!
3.2.3

Welding

Risk of injury! Keep a safe distance from the machine when mechanically closing
clamps and moving workpieces. Keep hands, limbs and objects such as clothing,
tools etc. away from running machine!
While moving workpiece ends to welding position, read the workpiece drag pressure from
the manometer on the hydraulic unit.
The workpiece drag pressure is the minimum amount of pressure required to set the workpiece
– depending on weight and length – in axial motion. This value must be precisely determined; it
will be necessary to engage and disengage the machine and workpieces several times and to
set the pressure adjustment valve until the machine almost comes to a standstill. Add the drag
pressure to the conformation, heat-penetration and joint pressure.
Insert the heating plate into the basic unit between the two workpiece ends and make sure
that the heating plate's supports are seated in the notches on the take-off device.
Engage the machine, set and maintain the required conformation pressure plus drag pres-
sure.
As soon as sufficient bead has formed around the entire circumference of the workpiece
ends, slowly release the pressure by slowly opening the relief valve.
Set the pressure so that workpiece ends have uniform almost pressureless contact to the
heating plate (warm up).
Now close the relief valve. Ensure that the workpiece ends still have contact with the heating
plate.
After the warm-up phase, disengage workpieces, remove the heating plate and re-engage
the workpieces. Increase the pressure linear to the respective joint pressure and maintain
that pressure until the joint is fully cooled.
Regularly check the pressure and pump it back up when necessary. If the pressure loss is
excessive, have the hydraulic system checked.
CAUTION: Press and hold the control lever for the first 20 to 100 seconds then release
(neutral switch position).
Put the heating element back into the storage case.
After the joint has fully cooled, slowly release the pressure by opening the relief valve, un-
clamp the workpieces and remove from the machine.
Disengage the basic unit, write protocol. The machine is now ready for the next welding cy-
cle.
All welding parameters can be found in the enclosed welding tables.
3.2.4

Putting out of operation

Switch off heating plate.
Let the heating element cool or stow it in such a way that no adjacent materials can
be ignited!
Remove trimmer unit, heating plate and hydraulic unit mains plugs from power outlet and roll
up cables.
Transport and set the hydraulic unit only in a horizontal position. If it is set at an
angle, oil escapes from the vented plugs with the dipstick!
Disconnect and roll up hydraulic hoses.
Important! Protect couplings from damage and dirt!
20 ENGLISH