English
Meaning of the
Warning ! Please refer to the User's Manual before using
the instrument.In this User's Manual, the instructions
preceded by the above symbol, should they not be carried
out as shown, can result in a physical accident or dammage
the instrument and the installations.
Meaning of the
This device is protected by a double insulation or by a
reinforced insulation. No linking is required from the protection
earth terminal to ensure the electrical security.
Meaning of CAT III symbol
This voltage surge category III clamp, with pollution level 2,
complies with stringent reliability and availability requirements,
corresponding to fixed industrial and domestic installations
(see IEC 664-1).
Thank you for purchasing a C.A 5260 multimeter.
To get the best service from this instrument:
read this user's manual carefully,
respect the safety precautions detailed
Use the correct fuse or risk damaging the device and rendering
your guarantee void.
0.1 A HRC safety fuse (660 V - 10 kA – 6.3 x 32 mm)
Never use on voltage networks exceeding 600 V (in relation
to earth) or in overload category III or higher, i.e. fixed industrial
and domestic installations (see IEC 664-1).
For indoor use only, in environments where the degree of
pollution is 2 at the most (see IEC 664-1), the temperature
is between O and + 50°C and the relative humidity is less
than 70%.
Use accessories that comply with the safety standards (NF
EN 61010-2-031) of 600 V voltage (min) and at least in
overload category III.
Never open up the multimeter casing before having
disconnected all electrical sources.
Never connect the multimeter to a measurement circuit if the
casing is not correctly closed.
Before any measurement is carried out, make sure that the
leads and switch are in the correct positions.
Never carry out resistance measurement on a live circuit.
In order to avoid damage to the K thermocouple, do not raise
the thermocouple voltage to above 24 V RMS or 60 DC in
relation to earth.
symbol
symbol
SAFETY PRECAUTIONS
12