Hach LINK2SC Manual Del Usuario página 3

Table of contents
Specifications on page 3
Product overview on page 3
Specifications
Specifications are subject to change without notice.
Product
sc1000 controller
sc200 controller
DR 3900
AN-ISE sc
Product overview
The LINK2SC software function enables optimum interaction of the process measuring equipment
and the photometer in the laboratory. It enables direct measurement correction of the online sc probe
via a photometer operating under laboratory conditions (refer to
on page 4). LINK2SC also enables laboratory control measurement. Measurement data is
transferred from the sc probe to the photometer, where it is then archived together with the
photometric reference data.
One or more online measurement values are used to create a job on the sc controller; this job is
transferred to the photometer via a local network connection or via SD memory card and USB
adapter. A job is an XML file containing measurement values and additional controller and probe
information.
The water probe drawn at the same time as this is analyzed in the laboratory in line with the same
parameters.
In the photometer, the photometric measured value is assigned to the probe value in the job. If the
job is then sent back to the sc controller, the probe is corrected automatically.
Data transfer is either via SD memory card or local network (LAN)
1
Only valid for sc1000 controllers.
Installation on page 5
Operation on page 5
Software version
V 1.3
V 1.0
V 1.0
V 1.03
Introduction to matrix correction
1
.
English 3