Work Sequence: Sc Controller - Hach LINK2SC Manual Del Usuario

Work sequence: sc controller

Menu structure based on sc1000 controller; the menu structure for the sc200 may differ slightly.
MENU
SENSOR STATUS
SENSOR SETUP
SYSTEM SETUP
SERVICE
LINK2SC
CREATE JOB
SENSOR NAME (in this case: ANISE SC)
Submenu: parameter selection
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Parameter 5
Parameter 6
Once the parameter is selected, a request for a sample is generated
LINK2SC
SAMPLE NUMBER
JOB->LAB
Confirmation is displayed once the job has been sent.
JOBS FROM CARD
JOB LIST
JOB 1
ANISE SC
JOB INFORMATION
NEW MEASUREMENT Trigger new measurement for MATRIX2 correction.
Submenu: parameter selection
JOB->LAB
ACTIVATE JOB
ERASE JOB
JOB N
CONFIGURE
Here: NH -N + NO
4
Here: NH -N
4
Here: NO -N
3
Here: NH -N + K
4
Here: NO -N + Cl
3
Here: NH -N + K + NO
4
Job displayed in job status menu with:
Sample number
Select and confirm
Only active when processed jobs from the laboratory are present on the SD memory
card.
Job list containing all jobs.
Job with number and date.
Probe information
Job number
Send job to laboratory.
Activate job entered via SD memory card.
Delete the job from the list.
Job with number and date.
LINK2SC configuration
Refer to sc controller user manual.
Refer to sc controller user manual.
Refer to sc controller user manual.
Refer to sc controller user manual.
Select to call up the LINK2SC menu.
Create a new job.
Select the required probe (e.g. AN-ISE SC).
-N
3
-N + Cl
3
English 7