Remote Jack - Sony SVO-1330 Manual De Instrucciones

REMOTE jack

This VCR can be remotely controlled by adding the
circuit shown below to the REMOTE jack or by using
the SVT-RM10 Remote Control Unit (not supplied).
REMOTE jack
SW1 ......... STOP
SW2 ......... PAUSE
SW3 ......... REW
SW4 ......... FF
SW5 ......... PLAY
SW6 ......... REC
SW7 ......... MENU
SW8 ......... REV PLAY
SW9 ......... TRACKING/DATA –
SW10 ....... TRACKING/DATA +
SW11 ....... SHIFT v
SW12 ....... SHIFT b
Resistor tolerance should be equal
to or less than ±2%.
Note
Use a shielded cable less than 5 m (16 ft.) in length.
Using recording status output signal
Using a stereo miniplug to output the recording status
signal from the REMOTE jack. The pin allocation of
the Remote IN and Recording Status OUT is as shown.
The recording status output signal functions as
follows:
• When recording: 5 V signal is output.
• During recording pause: the signal slowly turns on
R2 1.5K
and off repeatedly (about 1 Hz).
SW1
• If something is wrong with recording: the signal
R3 0.43K
SW2
rapidly turns on and off repeatedly (about 4 Hz).
R4 0.51K
SW3
• At the end of the tape: the signal turns on about one
R5 0.62K
SW4
second, then turns on and off rapidly twice
(equivalent to 4 Hz).
R6 0.75K
SW5
R7 0.91K
SW6
R8 1.1K
SW7
R9 1.3K
SW8
R10 2.0K
SW9
R11 2.4K
SW10
When using the SVT-RM10 Remote Control
R12 3.6K
SW11
Unit
R13 5.6K
SW12
When the SVT-RM10 Remote Control Unit (not
supplied) is connected to the REMOTE jack, the REC/
PLAY SPEED $/4 buttons on the SVT-RM10
function the same as the TRACKING/DATA +/–
buttons on the VCR.
When using the FS-20 Foot Switch
To connect the FS-20 Foot Switch (not supplied) to the
REMOTE jack, an internal modification is required.
Consult your Sony dealer.
Ground
Recording Staus OUT
Remote IN
1 sec. 1 sec.
5 V
0 V
25
(US)