Recording The Date And Time; Setting The Timing Of The Tape-End Alarm; Setting The Mode At The End Of The Tape - Sony SVO-1330 Manual De Instrucciones

Recording

Recording the date and time

You can record the recording date and time on the tape
together with the picture.
6
ON SCREEN ON/OFF
Set the ON SCREEN ON/OFF switch to ON. The
current date and time are displayed on the screen. If
you start recording in this condition, the displayed date
and time are recorded on the tape together with the
picture.
To turn off the date and time, set the ON SCREEN
ON/OFF switch to OFF.
Setting the timing of the tape-
end alarm
You can select the timing at which the TAPE END
buzzer beeps to indicate the tape reaches its end or the
nominal tape length (before its end).
1
Press MENU and select 3.SET UP/USED TIME
using SHIFT v, then press SHIFT b.
The SET UP menu appears on the screen.
2
Press SHIFT v to flash the setting of "END
ALARM."
3
Set "END ALARM" to END or 02:00 for example
(nominal tape length), using DATA +/–.
[ SET UP ]
TAPE T-120
END ALARM END
TAPE END REW
APC ON
CLOCK ADJ 0 1 : 0 0
BUZZER ON
THREAD CHECK ON
[ USED TIME ]
HEAD 00005H
14
(US)
END: An alarm signal is output when the tape
02:00, etc.: An alarm signal is output when the
r P
p 0 ( )
4
Press SHIFT v to flash the setting of "TAPE" and
set it to T-120 or T-160 using DATA +/–.
(You may skip this step if you set "END ALARM"
to END in step 3.)
5
Press MENU twice to return to the normal display.
Setting the mode at the end of
the tape
You can rewind or eject the tape when it comes to the
end during recording.
1
Press MENU and select 3.SET UP/USED TIME
using SHIFT v, then press SHIFT b.
The SET UP menu appears on the screen.
2
Press SHIFT v to flash the setting of "TAPE
END."
reaches its end.
tape counter shows the set time (that is, the
nominal tape length in hours and minutes).
The time that appears depends on the setting of
"TAPE" and the recording tape speed (SP or
EP). Set the tape length correctly on "TAPE"
(T-120 or T-160).
When "TAPE" is set to T-120, 02:00 appears in
SP mode or 06:00 in EP mode;
When "TAPE" is set to T-160, 02:40 appears in
SP mode or 08:00 in EP mode.
[ SET UP ]
TAPE T-160
END ALARM 0 2 : 4 0
TAPE END REW
APC ON
CLOCK ADJ 0 1 : 0 0
ON
BUZZER
THREAD CHECK ON
[ USED TIME ]
HEAD 00005H