Assembly - Dolmar PS-352 Instrucciones De Manejo

ASSEMBLY

WARNING:
• Before performing any work on the guide bar or saw chain, always switch off the
engine and make sure that the cutting tool is stopped.
• Always wear protective gloves.
CAUTION:
• Start the chain saw only after having assembled it completely and inspected.
Installing guide bar and saw chain
NOTICE:
• Installing or removing saw chain should be carried out in a clean place free from
sawdust or other foreign material.
Put the chain saw on a stable surface and carry out the following steps:
1. Release the chain brake by pulling the front hand guard.
2. Loosen chain tension fully.
3. (For model PS-352) Unscrew the retaining nuts.
(For model PS-352 TLC) Press and fully open the lever until it stops. Turn the
lever counterclockwise.
4. Remove the chain cover.
NOTICE:
• You can not remove the chain cover without releasing the chain brake.
13
PS‑352
PS-352 TLC
PS-352 TLC